The trench should usually be mm wide. The trench should be safe and secure and not likely to cave in. Ideally the gas pipe connection will run down in a gentle gradient away from the building requiring gas towards the main. What type of pipe is used for underground gas lines? Can you use PVC for gas line? White Schedule 40 PVC pipe has never been approved for use in natural gas piping. At one time there was a yellow PVC pipe that was approved. If installed properly, no portion of the yellow PVC pipe could be above ground.
Does black gas pipe rust? It is very common to see black pipe used for your natural gas line and sprinkler system lines. Since black pipe has no protective coating, it may rust easily in wet or humid environments. To stop the pipe from rusting or corroding on the outside, you should provide a layer of protection on the outside of the pipe. How do you protect underground gas pipes?
Gas Pipe Protection from Corrosion Protect metallic gas pipe in an approved manner if exposed to corrosion.
Use factory-applied protective coatings on metallic gas piping and fittings. Use insulating couplings or fittings when joining dissimilar metals underground. How long do underground gas pipes last? Can you bury galvanized gas pipe? Natural gas is among the least expensive and most efficient ways to fuel a furnace or boiler.
Along with its advantages come safety concerns and responsibilities for homeowners. As a home inspector, it is your job to help identify deficiencies that can compromise the safety of occupants in homes using natural gas. We will discuss some of the basics of inspecting gas piping.
The piping inside the house is called the gas supply line or building line. Branch lines run to individual appliances. The branch line terminates in a drop line, which is a vertical pipe dropping down to the appliance from an overhead branch line.
This drop line is called a riser if it carries gas up to an appliance from a branch line below the appliance. At the appliance connection point, there usually is a sediment trap or dirt pocket, sometimes called a drip leg that includes a nipple and a cap.
This pipe extension usually is at least 3 inches long and is intended to catch any water or foreign material that may be in the gas before the material gets into the appliance itself. This is simply a gravity system, with the solids and liquids falling into the pocket. The piping downstream of the gas meter usually is the responsibility of the homeowner. The piping upstream of the gas meter and the meter itself usually are the responsibility of the gas company.
Steel, copper, brass: The most common gas piping is black steel. Galvanized steel, copper, brass or CSST Corrugated Stainless Steel Tubing also can be used in some areas, but some utilities specifically prohibit the use of copper. Manufacturer educates and certifies all installers to maintain their rigorous standards. Professional Web Design by Centauria. Pipe and fittings provide a continuous length of pipe with few if any connections within the walls. The fewer the connections, the lesser the chance of future gas leaks.
Fewer holes are cut in the drywall during installation. Any Wardflex pipe installed within six feet of the ground, especially when located in a garage or strapped down low to the side of the house, must be protected against damage by a vehicle or lawn mower by a conduit of PVC pipe.
0コメント